Crest Audio NEXSYS - VERSION 3.0 Manual de usuario descargar pdf (Pagina 7)

NPUT

ODULES

Input

Includes a 26dB Pad for mic input, 48V phantom power

(disabled when Line selected), rear panel Ground Lift switch,

Input Gain control, separate Balanced 1/4" Insert Send and

Return jacks.

Line Input Switch – Selects line input from either 1/4" phone

jack or normalled XLR jack (inserting 1/4" plug disconnects

associated XLR connector). Separate electronics are used in

the Line path.

Peak LED – Illuminates when preamplifier section is within

4dB of clipping.

Insert On Switch – Activates Insert Return circuit.

Insert Send active at all times.

Insert Post Switch – Changes location of insert point from

normal pre-EQ position to post-EQ position.

Continuously Variable High Pass Filter – Sweep variable

from 20Hz to 400Hz, Steep 18dB/octave slope with on/off

switch.

Fully parametric four-band with Q variable from 0.7 to 3.0

(center detent at 1.5) with 15dB boost and cut.

High Band – Bell shape, frequency variable from 1kHz to

20kHz. When Q control is turned full clockwise, band

switches to shelving type with tunable corner frequency.

High Mid Band – Bell shape, variable frequency from 400Hz

to 8kHz.

Low Mid Band – Bell shape, frequency variable from 100Hz

to 2kHz.

Low Band – Bell shape, frequency variable from 40Hz to

800Hz. When Q control is turned full clockwise, band

switches to shelving type with tunable corner frequency.

EQ On Switch – Inserts EQ into signal path, independant of

the High Pass filter.

Mono Input Control

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Sin comentarios

Crest Audio NEXSYS - VERSION 3.0 Manual de usuario Pagina 7