Crest Audio NEXSYS - VERSION 3.0 Manual de usuario descargar pdf (Pagina 8)

NPUT

ODULES

Dual Concentric Aux Sends 9 –16

Controls the level of signal sent to the master Aux output sec-

tion. Used to generate mono or stereo mixes for use as effects,

monitor sends, or customer defined auxiliary mono or stereo

mixes.

Aux Sends 9-16 – Four dual-concentric controls, each with

push-on/push-off switch, status LED (unlit=Send off,

green=on, red=on but muted), and pre-fader switch.

Internal Jumpers – Select pre-fader switches as pre or post

EQ and determine if Sends obey Channel Mute. Seperate sets

of jumpers for Sends 9-12 and 13-16.

Mono Aux Sends 1–8

Controls the level of signal sent to the master Aux output sec-

tion. Used to generate discrete mixes for use as effects or

monitor sends.

Aux Sends 1-4 – Four controls, each with push- on/push-off

switch, status LED (unlit=Send off, green=on, red=on but

muted), and pre-fader switch.

Aux Sends 5-8 – Four controls, each with push-on/push-off

switch, status LED (unlit=Send off, green=on, red=on but

muted), and pre-fader switch.

Internal Jumpers – Select pre-fader switches as pre- or post-

EQ and determine if Sends obey Channel Mute. Seperate

jumpers for Sends 1-4 and 5-8.

Monitor/Solo Functions

Eight-Segment Input Level Indicator – Monitors pre- or post-

fader signal level as determined by global switch in master

section. Dynamic indication (dim to full brightness) on bot-

tom LED. Top red peak LED samples at 3 points (pre-EQ,

post-EQ, post-fader) for signal within 4dB of clipping.

VCA Level LED – Variable green intensity shows gain

of channel VCA. Total gain is limited to 20dB; the LED turns

red if a level over this is called for (possible because of assign-

ment to multiple VCA groups). Note: This is NOT audio limiting.

Solo – Solos the channel according to mode selected in the

Master section. When in PFL Mode, a mono pre-fader signal

is monitored; AFL selects a panned (stereo) signal derived

after the fader.

Aux Sends (9-16)

Aux Sends (1-4 Shown)

Monitor/Solo Functions

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Sin comentarios

Crest Audio NEXSYS - VERSION 3.0 Manual de usuario Pagina 8